Discontinued

CAN BUS car alarm DS 500 CAN

#Bez príslušnosti k firme | DS 500 CAN

DS 500 CAN is car alarm suitable for vehicles with CAN BUS network and remotely controlled via an original remote control. Easy set up via USB and setup software. In dependence on vehicles type it is possible writes command into CAN BUS like lock/unlock door, open trunk, light flash or windows close.


Discontinued

This car alarm is controlled via original remotes controller supplied with vehicle. The car alarm recognize when you will unlock or lock your vehicle and according to that will is activate or deactivate. If doors or trunk will be opened or interior sensor will be triggered siren will go. During alert PAGER output is activated and can activate other module (example GPS module). Moreover car alarm disposes one input for additional module like shock or tilt sensors.

For special purpose is possible connect Module DS 500 DO. When module is connected to main unit will be possible to use additional remote controllers supplied with module DS 500 DO. The module DS 500 DO operates as car alarm remote control and central locking system, too. The car alarm DS500 can control lock/unlock vehicle in analogue or CAN mode.

For more security is possible extend the car alarm DS500 with Module DS 500 Joker 2. This module supplied special transmitter JOKER. Only when the JOKER is near to vehicle is able start engine or continues to driving (known as Anti-hijacking mode).

The connecting of car alarm DS 500 into vehicles is very simple. Many components into vehicle is available via CAN BUS, therefore not needs complicated installing into chassis or found signals into harness or wire loom.

Description

  • 2 separate inputs for sensors.
  • Switched supply of additional sensors.
  • possibility to activate alarm without certain sensors beeing active.
  • valet (service) mode option.
  • trunk release button logic.
  • memory of alarm triggering for 5 cases.
  • state of system is saved also, if power is suddenly cut.
  • signalization, if alarm was in nonstandard state.
  • signalization of door open, trunk, bonnet by activating of alarm.
  • function ignition safety lock.
  • function passive arming.
  • function of reactivation.
  • option to activate function IMMOBILIZER.
  • detection of alarm state from original alarm ( in certain vehicles).
  • direct command of lights trough CANBUS ( in certain vehicles).
  • programming and updates of firmware trough USB.
  • optional control of central locking with RF Module.
  • optional remote control with RF Module.
  • optional signalization of reverse gear

Remote

  • Optional - Module DS 500 DO 3T
  • Optional – Module DS 500 Joker 2

CAN BUS

  • 1 way connection
  • 2 way connection
  • Read and write data

Sensors

  • one zone additional sensor inputs (front side)
  • one zone additional sensor on rear side (optionally as two zone)
  • bypass sensors by valet switch
  • automatic bypass defective sensor

Inputs/Outputs

  • mini USB port for connection with PC
  • additional one zone sensor input
  • trunk/hood input
  • lights output (+12V/10A)
  • sequential output for directional light
  • ignition input (optional)
  • pager output
  • built-in immobilization circuit (30A NC)
  • analogue status inputs (optionally depend on vehicles)

Safety features

  • Ignition safety door lock
  • alarm memory
  • Passive arming
  • quiet / loud activation
  • rearming
  • Function Anti-hijack and function Immobilizer
  • Anti-hijack PIN authorization
  • emergency deactivation by PIN code

Set includes

  • main unit
  • siren 20W
  • harness
  • indicator LED
  • valet switch
  • manual
  • bonnet switch

Parameters

Connection CAN-BUS
Weight 0.66 kg

Need help?

Our technical support staff is ready to help and assist our customers. On the phone, by email or instant messaging on working days 8am-4.30pm

Technical support